How to make Hash

2009.04.27

Making Hash is a very simple process. You may be asking what Hash even is. Hash is short for Hashish. The correct definition for hashish is resin extracted from the flower clusters and leaf tops of the hemp plant, Cannabis Sativa and C. Indica. Hashish is also known as Charas in India. Hash is illegal in the United States. The more popular form that also comes from the hemp plant is Marijuana. It is less potent than Hash though. It is usually smoked just like marijuana.

There are probably many ways to make Hash. This is the simplest way that is known to make hash. This is also a good way to make hash if you do not have a lot of Marijuana to work with.

There are a few items that you will need in the making of this product. You will need a butter knife, a plastic sandwich baggy, a coffee grinder, a lighter, a small paint brush (not used) and a plate or something to put the unmade product in.

The first thing that you need to do is to put your marijuana in the coffee grinder. Start the grinder and grind the marijuana until you see crystals form in the top of the grinder. It will be a tan, powdery looking substance.

Take your plastic sandwich baggy and cut the middle out of it in the form of a square. Start cutting at the bottom of the baggy so there will only be three sides of the square cut. Keep the excess baggy close by because you will be using it later on in this process.

Take the part of the baggy that you cut, set it in front of you and unfold it. Go back to the coffee grinder. Dump the crystal, powdery substance in the plate. Take the unused paint brush and brush out the remaining substance that is in the coffee grinder and put it on the plastic baggy. Fold over the baggy so that it is covering the crystal.

Take the end of the paint brush and flatten the substance in between the two sides of plastic. Once this is done, you will need to get the butter knife and lighter.

You will need to get the butter knife and heat it with a lighter for five seconds. Take the butter knife and smash the heated side against the plastic just until it changes the color of the substance. Do not get it too hot fore it will melt the plastic onto the substance and ruin it. You can test how hot your knife is on the excess plastic that you put aside earlier.

Open up the plastic slowly. Fold the hardened crystal to make it smaller and thicker. Heat your knife up again and press it upon the substance that is covered once again with the plastic. Repeat this process until you have a decent thickness of the substance. Cut this into small squares. This is what you call hash. Now I guess you will put it on a pipe and smoke it.